AEG RCB531E1LW Kullanıcı Kılavuzu - Sayfa 16

Dondurucu AEG RCB531E1LW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG RCB531E1LW 24 sayfaları.

AEG RCB531E1LW Kullanıcı Kılavuzu
16
www.aeg.com
Problem
The compressor does not
start immediately after
pressing the "FROSTMAT‐
IC", or after changing the
temperature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
Side panels of the appliance
are warm.
The lamp does not work.
There is too much frost and
ice.
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The FROSTMATIC function
is switched on.
The compressor starts after
a period of time.
The appliance is not level‐
led.
You attempted to re-open
the door immediately after
closing.
This is a normal state
caused by operation of the
heat exchanger.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Solution
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to "FROSTMATIC
function" section.
This is normal, no error has
occurred.
Refer to installation instruc‐
tions.
Wait a few seconds between
closing and re-opening of
the door.
Make sure the appliance in‐
stallation is done according
to the instructions given in
this user manual.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.