AEG SANTO 70398-28 DT Kullanım Talimatları Kılavuzu - Sayfa 25

Dondurucu AEG SANTO 70398-28 DT için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AEG SANTO 70398-28 DT 40 sayfaları.

– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature corresponds to
the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is located
at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each
climate classification: each climate classification:
Climate classification
If installation next to a source of heat is unavoidable, the following
minimum clearances must be maintained at the sides of the appliance:
– for electric cookers 3 cm;
– for oil and coal fired ranges 30 cm.
If these clearances cannot be main-
tained a heat insulating pad is requi-
red between the cooker and the
refrigeration appliance.
If the refrigeration appliance is
installed next to another refrigerator
or freezer a clearance of 5 cm at the
sides is required, in order to prevent
the formation of condensation on
the outside of the appliance.

Your appliance needs air

For safety reasons, minimum ventila-
tion must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction.

Rear spacers

Inside the appliance you find two
spacers which must be fitted.
Slacken the screws and insert the
spacer under the screw head, then
retighten the screws.
SN
N
ST
T
for an ambient temperature of
+10 bis +32 °C
+16 bis +32 °C
+18 bis +38 °C
+18 bis +43 °C
NP005
25