Acard ANS-9010 Hızlı Kurulum Kılavuzu - Sayfa 6

Bilgisayar Donanımı Acard ANS-9010 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Acard ANS-9010 18 sayfaları. 5.25” ram disk

4. Close the upper cover with four screws

Jumper Setting

There are jumpers on the rear site of the ANS-9010. Refer to the following descriptions to set

jumper according to your application.

SATA Power

connector

1. SATA Port0, Port1 working mode

Open: Single mode (default)

Through the SATA port0, we can access the total capacity of DDR2 SDRAM DIMM.

SATA port1 will be disabled.

Short: Dual mode

Each SATA ports can be accessed to one disk with half capacity of total DDR2 SDRAM

DIMM. With this mode enabled, we can double the data transfer rate by configure them

as a RAID0 (stripping) logical disk if the SATA host supports RAID function.

2. SATA port transfer rate

For various application environment, the ANS-9010 was allowed to set the SATA transfer

rate to higher performance one (3.0Gbps) or higher compatibility/stability one(1.5Gbps)

if your SATA controller doesn't work well with ANS-9010.

Open: SATA 3.0Gbps(default)

Short: SATA 1.5Gbps

SATA

Port0

Port1

II.

SATA Port0, Port1 working mode

Reserved

SATA transfer rate

Reserved