Aqua Medic Refill System easy Kullanım Kılavuzu - Sayfa 4
Kontrol Ünitesi Aqua Medic Refill System easy için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aqua Medic Refill System easy 10 sayfaları.
Ayrıca Aqua Medic Refill System easy için: Kullanım Kılavuzu (12 sayfalar)
Sayfayı Yazdır
The level control Refill System easy is an automatic top up unit for salt and fresh water aquaria.
1. Safety instructions
-
Read the instructions carefully before taking the unit into operation.
-
Protect the power supply and connections from moisture, splash and condensate.
-
Suitable for indoor use only. Do not expose to the weather or frost.
-
Not suitable as a toy for children.
Fig. 1: 1. Power supply 2. Sensor
8. Aquarium or filter tank 9. Spot for a hole against communicating tubes 10. Plug connection
2. System connection
The outlet pipe must not be lower than the water surface otherwise the water will flow back from the aquarium
to the reservoir. In order to avoid draining the water reservoir due to "communicating tubes", a hole can be
made at this spot in the tube (No. 9).
3. Meaning of the indicator light
-
Water shortage or error (red)
-
High level sensing point (flash slowly)
-
Low level sensing point (green)
-
Water shortage (lights off)
4. Notice
-
Protective cover must be installed.
-
The water outlet should not be near the probe.
-
If you unplug the power plug and water is still running, you have "communicating pipes". In this case, put a
1 mm diameter hole in the tube (No. 9). After putting the hole in, water flows back into the reservoir while
the pump is running. That is normal. When the pump is turned off, air enters the tube through the hole and
prevents the formation of "communicating tubes".
4
Operation Manual ENG
3. Magnet 4. Pump 5. Tube
6. Tube holder 7. Supply tank