aqua metro CALEC ST Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 6
Kayıt Ekipmanları aqua metro CALEC ST için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. aqua metro CALEC ST 12 sayfaları. N2open bus interface
Ayrıca aqua metro CALEC ST için: Manuel (16 sayfalar)
Sayfayı Yazdır
7
Setting the analog outputs
®
The CALEC
ST must be in the Service mode in order to set parameter values for the analog outputs (see the
installation and operating manual for CALEC
®
If the CALEC
ST is in User mode, then parameter values can only be read but not set.
Setting parameter values of the analog output is carried out in the sublevel OutPutS.
• Press the
key until OutPutS is shown in the display.
• Press the
key to activate sublevel OutPutS.
• Press the
key until the output to be set is shown.
• Press the
key to activate the parametering level of analog output 1 (No. 3) or analog output 2 (No. 4).
1. Function of the analog output (short text in display Fct )
Press the
key to activate the Edit mode (Edit shown in display)
Press the
key to select the function and confirm by pressing the
Press the
key for the next display
2. Output variable (short text on display Med )
Press the
key to activate the Edit mode (Edit shown in display)
Press the
key to select the function and confirm by pressing the
Press the
for the next display
3. Value corresponding to 0 or 4 mA (short text in display 0/4)
Press the
The values are set for each position from right to left
Set each value with the
Press the
key for the next display
4. Value corresponding to 20 mA (short text in display 20)
Press the
The values are set for each position from right to left
Set each value with the
Press the
key for the next display
6
®
ST, page 20 + 21).
1 =
No.
2 =
No.
3 =
No.
4 =
No.
InActiuE
0-20 mA
4-20 mA
tESt
t-hot
t-cold
t-diFF
POUEr
FLOU
dEnSitY
C-FActor
key to activate the Edit mode (Edit shown in display)
key and confirm by pressing the
to activate the Edit mode (Edit shown in display)
key confirm by pressing the
Relay output 1
Relay output 2
Analog output 1
Analog output 2
=
Analog output without function
=
Current range 0 ... 20 mA
=
Current range 4 ... 20 mA
=
Test function
=
Temperature hot side
=
Temperature cold side
=
Temperature difference
=
Power
=
Flow
=
Density
=
C-factor
key
key
key
key