AVPro Edge ConferX AC-CXMF62-AUHD Hızlı Başlangıç Kılavuzu - Sayfa 5

Matris Anahtarlayıcı AVPro Edge ConferX AC-CXMF62-AUHD için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AVPro Edge ConferX AC-CXMF62-AUHD 6 sayfaları. 6 input, 2 output multi-format classroom/conference room matrix switcher

Sayfayı Yazdır
IR Ports
Used for IR extension over HDBT. Choose IR Input type using the dipswitch on the
back of the unit.
• IR Eye = IR from remote/emitter
• IR Pass = IR direct from control system
• IR can be routed. By default, the switch comes in:
• IN1/OUT1 = Bound to HDBT Input
• IN2/OUT2 = Bound to HDBT Output
MIC IN
Allows for a mic to be injected into the extracted audio outputs. Select
Microphone type by using the dipswitch located next to the input.
• Line In = Line level input (PC, Phone, etc..)
• MIC = Microphone input for dynamic microphones
• 48V = Microphone input for condenser microphones. Provides
48V Phantom Power.

Troubleshooting:

We recommend every integrator has a fox and hound testing and troubleshooting kit to ensure quality hdmi
connection.
• Verify Power - The LEDs on the front of the matrix should be lit up when power is
• applied. Check power supply connections to device and power
• Verify Connections - Check all cables are properly connected
• Issues with one INPUT/OUTPUT- Swap ports to see if the issue stays with the port or
• with the device
• Follows the device, then it may be an EDID issue. Default out of the box is
• a 1080p 2ch. Try another canned EDID
• Try another canned EDID or use the COPY FROM OUTx command to copy the
• Issues with 4k but 1080 or less working
• Verify all connected devices are capable of the signal you are sending
• Turn on the Test Pattern Generator for each of your outputs to verify signal is passing through your run
Have a question or need assistance?
Don't hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112