AVPro Edge AC-EX100-UHD-KIT-P Hızlı Başlangıç Kılavuzu - Sayfa 2
Genişletici AVPro Edge AC-EX100-UHD-KIT-P için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AVPro Edge AC-EX100-UHD-KIT-P 3 sayfaları. 100m hdbaset kit
Sayfayı YazdırRS-232 Configuration
RS-232 can be used to pass control signals bi-directionally to &
from any RS-232 compatible device.
In order to connect your computer to the extender by rs232 you need to
make your own cable with one end a phoenix connector and the other end
a rs-232 port. your computer doesn't have a rss-232 input, get a usb con-
verter (as shown below) and plug the usb end to any computer.
IR can be used in two ways:
From Rack (Control System Direct):
Plug a MONO 3.5mm cableinto an emit-
ter port of any control system directly into the IR IN (maybe labeled IR RX) Port
on the AC-EX100-UHD Tx to send pass IR Signals directly to the remote end. On the
Rx use the provided emitter on the IR OUT (may be labeled IR TX)
From Remote End:
Use and IR Sensor Provided on the AC-EX100-UHDRx IR IN (May
be labeled IR Rx) and send IR Signals BACK to therack and comeout of theTX IR Out
Port (may be labeled IR Tx) witha provided emitter.