Avtech DGC1304XFT Kullanıcı Kılavuzu - Sayfa 6
Güvenlik Kamerası Avtech DGC1304XFT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avtech DGC1304XFT 7 sayfaları. Ir dome camera
Sayfayı Yazdır
MENU
DAYNIGHT
EXT
B&W
OFF
IMAGE
NR
DWDR
PRIVACY
MOTION
ALS IN
0 ~ 255
DELAY
AUTO
MANUAL
STRENGTH
OFF
ON / OFF
OFF
ON
COLOR
MASK SEL
MASK DRAW
OFF
ON (BORDER)
AREA SEL
POSITION
SENSITIVITY
COLOR
TRANS
DESCRIPTION
Set the delay time in second after which the day and night
switch is made.
This is used for the environment where the light condition
may change suddenly and usually last for a short time, for
example, the entrance of a parking lot. It may cause the
day & night mode switching constantly and damage the
camera.
With this function, the camera will delay the mode switch
at night since the light change is temporary and
unnecessary to pay attention.
Always keep the day and night mode to night mode.
Always keep the day and night mode to day mode.
Automatically reduce noise in the image based on the
current environment.
Set the level to enable noise reduction.
Choose to disable this function.
DWDR is used to increase image recognizability in
overexposure and dark areas.
Choose ON / OFF enable / disable this function.
Disable this function.
Choose the color for the area selected in MASK SEL.
You can choose NO COLOR to disable this function,
MOSAIC for mosaic display, or 1 ~ 14 for different
colors.
Select the area you want to mask. Up to four areas could
be configured.
Set the size of the masked area:
1. Click
and change the
size by clicking
,
,
and
.
3. Click
again to finish and exit.
Choose to disable motion detection.
Select the area you want to detect. Up to four areas could
be configured.
The area will be framed and flashed when a motion event
occurs.
Choose ON to show where the area selected in AREA
SEL is and set the size of the area:
1. Click
and change the
size by clicking
,
,
and
.
3. Click
again to finish and exit.
Set the sensitivity for motion detection.
The larger the value, the more sensitive the detection.
Choose the color for the selected area to show when a
motion event occurs: RED / GREEN / BLUE / WHITE.
Choose the transparent level for the selected area when
a motion event occurs.
The larger the value, the more transparent the area.
2. Click
again and
change the size by clicking
,
,
and
.
2. Click
again and
change the size by clicking
,
,
and
.