Dell PowerEdge 2400 Kurulum Kılavuzu - Sayfa 7

Sunucu Dell PowerEdge 2400 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 2400 8 sayfaları. Wake-on-lan (wol) support on dell servers
Ayrıca Dell PowerEdge 2400 için: Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (8 sayfalar), Raf Kurulum Talimatları (32 sayfalar), Güncelleme (2 sayfalar), Etkinleştirme Kılavuzu (8 sayfalar), Güncelleme Kılavuzu (2 sayfalar), Manuel (15 sayfalar)

Thumbscrew

Power connector P2

10. Attach the 24-conductor cable labeled "PWR1" to connector P1 on the PSDB and

connector POWER1 on the system board.

11. To attach the cable harness provided in the upgrade kit, perform the following

steps:

Attach the 18-pin connector labeled "PWR2" to connector P2 on the PSDB.

Attach the 16-pin connector to the connector labeled "POWER" on the SCSI

backplane board.

Connect the remaining connectors on the cable harness to the diskette

drive, tape drive, and other drives in the external drive bays.

12. Replace the top cover and secure it with the two screws.

13. Replace the two computer covers.

()"*) , $ ,'

, $

Using your thumb and index finger, squeeze the catch in the middle of the power

supply handle (see Figure 1-3).

Rotate the handle downward.

()"*# - $ , + ,

Slide the power supply into the chassis (see Figure 1-3).

Dell PowerEdge 2400 Systems — Installing Redundant Power Supplies

Power connector P3

Power Connector P1

1-5