Dell 540s - Studio Slim Desktop Pc Servis Kılavuzu - Sayfa 14
Yazıcı Dell 540s - Studio Slim Desktop Pc için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell 540s - Studio Slim Desktop Pc 38 sayfaları. Service manual
Sayfayı YazdırBack to Contents Page
Replacing Drives
Dell Studio™ Slim 540s Service Manual
Replacing the Hard Drive
Replacing the Optical Drive
Replacing the Media Card Reader
Replacing the FlexDock
Removing the FlexBay/FlexDock Break-Away Metal Plate
Replacing the FlexBay/FlexDock Drive Insert
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
The system does not support IDE devices.
NOTE:
The 3.5-inch Media Card Reader is not interchangeable with the hard drive carrier.
Replacing the Hard Drive
NOTICE:
If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Disconnect the power and data cables from the hard drive.
NOTE:
If you are not replacing the hard drive at this time, disconnect the other end of the data cable from the system board and set it aside. You
can use the data cable to install a hard drive at a later time.
1 shoulder screws (4)
3 system board connector (any available connector SATA0,
SATA1, SATA4, or SATA5)
5 hard drive
7 serial ATA data cable
4. Press the lever on the side of the hard drive bay and slide the drive out and lift to remove the drive from the chassis.
NOTE:
If removing this drive changes the drive configuration, you must ensure that the changes are reflected in system setup. When you restart
your computer, enter system setup (see
Drive to the correct configuration.
NOTICE:
Ensure that you do not scratch the hard disk circuit board, while removing or replacing the hard drive.
5. To replace the hard drive, check the documentation for the drive to verify that it is configured for your computer.
Begin.
Replacing the Computer
Cover).
2 lever
4 power
cable
6 slot (2)
System
Setup), then go to the "Drives" section of the system setup and under Drive 0 through 3, set the