Miele DA 6290 W Çalıştırma ve Kurulum Talimatları - Sayfa 22
Havalandırma Davlumbazı Miele DA 6290 W için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. Miele DA 6290 W 40 sayfaları. Ventilation system
Ayrıca Miele DA 6290 W için: Çalıştırma ve Kurulum Talimatları (40 sayfalar)
Sayfayı Yazdır
Cleaning and care
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a little washing-up liquid.
Do not use undiluted washing up
liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters as upright as
possible in the lower basket. Ensure
the spray arm is not obstructed.
^ Do not wash at more than 65 °C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
22
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
^ Replace the grease filters, making
sure that the locking clips are facing
down towards the cooktop.
^ If a grease filter is inadvertently
replaced upside down, insert a small
screwdriver blade into the slit to
disengage the clip.
Resetting the operating hours
counter for the grease filters
After cleaning, the operating hours
counter needs to be reset.
^ Whilst the fan is switched on, press
the operating hours control l for
approx. 3 seconds until only the 1 is
flashing.
The grease filter symbol l lights up.
If the grease filters are cleaned before
the operating hours counter has
reached its maximum,
^ press the operating hours control
l for approx. 6 seconds until only
the 1 is flashing.