Miele DA 78 Kullanım Talimatları Kılavuzu - Sayfa 11

Havalandırma Davlumbazı Miele DA 78 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele DA 78 20 sayfaları.

Sayfayı Yazdır

Cleaning and care

Before carrying out maintenance

work, the cooker hood must be dis-

connected from the mains supply.

ensure that, depending on the con-

nection:

- it is switched off at the fused unit

or the fused unit switch is with-

drawn, or

- it is switched off at the wall socket

and the plug removed (do not pull

on the cable, only on the plug, or

- the mains fuse is withdrawn; or

- the screw-out fuse is removed (in

countries where this is applicable).

Ensure curent is not restored to the

appliance while maintenance or re-

pair work is being carried out.

Housing

The cooker hood housing can be

cleaned using hot water with a little

mild detergent. Dry using a soft cloth.

Never use cleaning agents contain-

ing soda, acids, chlorides or ab-

rasive substances, as these can

damage the surface material.

Grease filters

The re-usable metal grease filters in the

appliance remove solid particles from

the kitchen vapours (grease, dust, etc)

preventing soiling of the cooker hood.

Always clean the grease filters when

they are visibly saturated with grease,

or when their operating efficiency is re-

duced. They should be cleaned at

least every one to two months.

Cleaning and care

An oversaturated filter is a fire ha-

zard!

To remove the grease filters, push

the filter retention clips in towards

the middle.

Take the grease filters out and clean.

By hand: with a scrubbing brush in hot

water with detergent.

In the dishwasher: Place the filters

with the short side upright in the

lower basket, ensuring the spray

arm is not obstructed.

After cleaning, leave the filters to dry

for a while on an absorbant surface

before putting them back in place.

When removing the filters for clean-

ing also clean off any residues of oil

or fat from the now accessible hous-

ing to prevent the risk of these catch-

ing fire.

When replacing the filters, make sure

that the clips are visible, facing

down towards the hob.

Should a filter be replaced upside

down, insert a small screwdriver

blade into the slits to disengage the

clip. Do not let the filter drop onto the

hob below.