Miele DA 78 Kullanım Talimatları Kılavuzu - Sayfa 14

Havalandırma Davlumbazı Miele DA 78 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele DA 78 20 sayfaları.

Sayfayı Yazdır

Electrical connection

All electrical work should only be under-

taken by a suitably competent person

in strict accordance with national and

local safety regulations.

The data plate gives the necessary

data for connection. This is visible

when the rear grease filter has been

removed.

The cooker hood is supplied for con-

nection to a 220-230 V single phase

50 Hz supply.

Connection should be made either by a

double pole fused spur connection

unit, or a fused plug and switched

socket. The On-Off switch should be

easily accessible after the appliance

has been built in. For extra safety it is

advisable to install a residual current

device (RCD) with a trip current of 30

mA.

Important

The wires in the mains lead are col-

oured in accordance with the following

code:

Green/yellow

Blue

Brown

If the appliance is to be connected via

a plug and socket, please note the fol-

lowing:

As the colours of the wires in the mains

lead of this appliance may not corre-

spond with the coloured markings ident-

ifying the terminals in your plug, pro-

ceed as follows:

The wire which is coloured green and

yellow must be connected to the termi-

= earth

= neutral

= live.

nal in the plug which is marked with the

letter E or by the earth symbol z or col-

oured green or green and yellow.

The wire which is coloured blue must

be connected to the terminal which is

marked with the letter N or coloured

black.

The wire which is coloured brown must

be connected to the terminal which is

marked with the letter L or coloured red.

WARNING:

THIS APPLIANCE MUST BE

EARTHED

Non-rewireable plugs BS 1363 (UK)

If this machine or appliance is fitted

with a non-rewireable plug, the follow-

ing information applies:

If the socket outlets are not suitable for

the plug supplied with this product, it

must be cut off and an appropriate

plug fitted. The plug cut from the flex-

ible cord should be disposed of, and

on no account be inserted into any

socket elsewhere in the house (electric

shock hazard).

The fuse cover must be re-fitted when

changing the fuse and if the fuse cover

is lost the plug must not be used until a

suitable replacement is obtained.

The colour of the correct replacement

cover is that of the coloured insert in

the base of the plug (as applicable to

the design of plug fitted).

The correct fuse rating of the replace-

ment fuses that are ASTA approved to

BS 1362 should be fitted. Replacement

fuse covers may be purchased from

your local electrical suppliers or Ser-

vice agent.