Allo.com GSM Series Kullanıcı Kılavuzu - Sayfa 16

PCI Kart Allo.com GSM Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Allo.com GSM Series 20 sayfaları. Digital telephony card

Sayfayı Yazdır
GSM Digital Telephony Card User Manual – Version 1.0
Checking GSM modules & SIP peers using asterisk
CLI
After installing the chan_gsm.so module, you can check the gsm modules
which you have enabled in the configuration. As shown in following command.
allogsm
*CLI>
Port Status InUse Provider Home Zone Signal Quality
1 (0) REGISTERED n "Rogers Wireless" y -82dbm
2 (0) REGISTERED n "Rogers Wireless" y -82dbm
3 (0) REGISTERED n "Rogers Wireless" y -82dbm
4 (0) REGISTERED n "Rogers Wireless" y -67dbm
The fields here can be detailed as follows:
* Port column is the index to the GSM port.
* Status should be REGISTERED.
* InUse column indicates if the GSM port is busy.
* Provider gives the name of the provider.
* Home Zone indicates if we're registered to our regular provider.
* Signal Quality indicates how good the signal reception is.
For signal quality, we can translate the measurements as follows:
# not measurable (not measured yet)
# -112 dbm is very low
# -97 dbm is low
# -82 dbm is ok
# -67 dbm is good
# -52 dbm is high
# -51 dbm is very high
Similar to above command many other at commands can also be used as
bellow,
allogsm
send at <port> "<command>"
where port is the gsm port, command is "at+csq" for checking signal
strength.
Similarly we have many at commands which we can give as commands.
(at commands are generic gsm at commands which can be searched in
the internet)
WWW.ALLO.COM
show status
Page 16