Miller Welding Güvenlik Hızlı Kılavuzu - Sayfa 8
Kaynak Sistemi Miller Welding için çevrimiçi göz atın veya pdf Güvenlik Hızlı Kılavuzu indirin. Miller Welding 16 sayfaları. For arc welding and cutting the safe way
Ayrıca Miller Welding için: Kullanıcı El Kitabı (33 sayfalar)
Sayfayı Yazdır
Safety Quick-Guide
Page 7
Electric shock from torch or wiring can kill.
Wear dry insulating gloves. Do not wear wet or damaged gloves.
Do not touch live electrical parts.
Protect yourself from electric shock by insulating yourself from
work and ground. Use non-flammable, dry insulating material if
possible, or use dry rubber mats, dry wood or plywood, or other dry
insulating material big enough to cover your full area of contact
with the work or ground, and watch for fire.
Disconnect input plug or power before working on machine.
Do not make input connections if color blind.
Frequently inspect input power cord for damage or bare wiring —
repair or replace cord immediately if damaged. Be sure input
ground wire is properly connected to a ground terminal in
disconnect box or receptacle.
Properly install and ground this equipment according to its
Owner's Manual and national, state, and local codes.
Breathing cutting fumes can be hazardous to
your health.
Keep your head out of the fumes. Do not breathe the fumes. Use
enough ventilation, exhaust at the arc, or both, to keep fumes and
gases from your breathing zone and the general area.
Read Material Safety Data Sheets (MSDSs) for metals, consum-
ables, and coatings.
Use enough forced ventilation or local exhaust (forced suction) at
the arc to remove the fumes from your breathing area.
Use a ventilating fan to remove fumes from the breathing zone and
cutting area.
If adequacy of ventilation or exhaust is uncertain, have your
exposure measured and compared to the Threshold Limit Values
(TLV) in the Material Safety Data Sheet (MSDS).