Miller ArcStation Kullanıcı El Kitabı - Sayfa 10
Kaynak Aksesuarları Miller ArcStation için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller ArcStation 20 sayfaları.
Ayrıca Miller ArcStation için: Kullanıcı El Kitabı (44 sayfalar)
Sayfayı Yazdır
3-4. Installing Dust Tray
2
OM-247318 Page 6
2
1
AA and ZZ
Side View
1
Dust Tray Rails
Use the supplied four bolts AA and
four locknuts ZZ and install dust
tray rails to the welding table. Be
sure that dust tray rails are on the
inside of the subframe assemblies.
Tighten all bolts and locknuts.
2
Dust Tray
Install dust tray into rail slides as
follows:
Tilt rear of tray down and lift front of
tray up.
Place flange on rear of tray behind
angle iron support.
Lower
front
of
tray
until
approximately level.
Slide tray into position.
Tools Needed:
1/2 in.
hex bit 3/16 in.