Miller WP-18 Series Kullanıcı El Kitabı - Sayfa 13
El feneri Miller WP-18 Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller WP-18 Series 28 sayfaları.
Ayrıca Miller WP-18 Series için: Kullanıcı El Kitabı (20 sayfalar)
Sayfayı Yazdır
4-3. Connecting Torch
A. Connecting Torch To A PipeWorx With A PipeWorx Cooler
If applicable, install high-frequency unit.
1
12
Tools Needed:
11/16 in.
5
7
8
11
10
!
Turn Off welding power source
power before installing torch..
1
Welding Power Source
2
Gas Hose
3
TIG Block (Customer Supplied)
4
Coolant In Hose 237 416 (Short
Red Hose Supplied With Cooler)
5
TIG (−) Weld Cable/Coolant In
3
6
Coolant Out Hose
7
Work (+) Weld Cable
8
TIG Torch
9
Foot Control (Optional)
4
10 Workpiece
11 Work Clamp
Connect work clamp to a clean,
2
paint-free location on workpiece,
close to the weld.
Use wire brush or sandpaper to clean
weld joint area.
12 Volt Sense Lead
.
Attach volt sense lead to work
clamp and attach work clamp as
close to arc as possible.
6
9
802 560-A
OM-225 429 Page 9