Aquasana AQ-SFRO Kullanıcı El Kitabı - Sayfa 4
Su Filtrasyon Sistemleri Aquasana AQ-SFRO için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aquasana AQ-SFRO 13 sayfaları. Under sink water filter smartflow reverse osmosis
4
INSTALLATION STEPS
2
3
Install Drain Saddle
A. Identify drain outlet location on drainpipe to install drain clamp. Do not
install drain clamp on the same drainpipe as garbage disposal. Mount
drain clamp as low as possible on the vertical or
horizontal drainpipe tailpiece.
B. Using the drain connector hole as a template, drill a 7/16" hole into the
drainpipe. Only drill through one side of the drainpipe.
C. Take the connection half of the
drain clamp and attach the foam
gasket. Do so by removing the
center hole and protective cover
from the back of the foam gasket.
Align the foam gasket hole with
the hole on the inside of the drain
clamp. The adhesive side of the
foam gasket should be facing the
inside of the drain clamp. Press
firmly to attach.
D. Insert nuts into the other half of
the drain clamp. Place both halves
together around the drainpipe,
aligning with the hole you drilled.
Use drill bit to help align.
E. Tighten nuts and screws to secure
the drain clamp halves around the
drainpipe. Tighten with screwdriver.
Do not over tighten.
4
Install Inlet Tee Valve and Tubing
NOTE: Ensure water valve is turned off before continuing.
A. Place a pan or bucket under cold water line to catch any excess water.
With an adjustable wrench, disconnect COLD water line from the supply
line at shut-off valve.
B. Attach threaded ends of inlet tee valve to the cold water line of the
shut-off valve. Tighten with wrench. Do not over tighten.
C. Reattach the cold water line to the top of the tee valve.
D. Push white tubing into the open quick connect valve. Ensure inlet tee
valve is in the open position.
2
1
5
Install System Manifold and
Remineralizer Bracket
A. Place system manifold under the sink
in a place that will be easy to access for
scheduled filter changes. Do not install
filter cartridges at this time.
B. Using your screw driver and included
screw, install the bracket on your cabinet
wall near the system manifold. Insert
remineralizer cartridge with sticker
text upward.
NOTE: Placement of bracket must be close to system manifold to ensure tube
length needed for connection is sufficient.
INSTALLATION STEPS
CLOSED
OPEN
5