Olympus CX-DO Talimatlar Kılavuzu - Sayfa 8
Laboratuvar Ekipmanları Olympus CX-DO için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus CX-DO 13 sayfaları. Dual-viewing attachment
Sayfayı YazdırCX-DO
Fig. 6
A
The cords are vulnerable
when bent or twisted.
Never subject
them to excessive
force.
AMIC
a e sure that the main switch
is turned
to OFF before
connecting
the power cord.
1. Connect the pointer illumination cord plug @ to the connector @ on
the rear panel of the TDO transformer.
2. Connect the power cord plug @ to the wall outlet.
Fig. 7
1. Loosen the support pillar clamping knob @ and thread the upper section
@ of the support pillar into the socket @ located at the underside of
the secondary observer position on the dual-viewing
body.
2. Extend the lower section of the support pillar until the base is in contact
with the table surface.
* The dual-viewing
body should be parallel with the table surface.
3. Clamp the support pillar by tightening the support pillar clamping knob
0.
0
4