Axvue E660 Kullanım Kılavuzu - Sayfa 5

Bebek Monitörü Axvue E660 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Axvue E660 12 sayfaları. With 2.4" lcd screen and night vision

STRANGULATION HAZARD - Children have STRANGLED in cord out of reach of children, (more than

3 feet away from the crib). Use enclosed Security Clips to help secure cord away from baby's reach.

Never use extension cords with Adapters. Only use the Adapters provided.

Before using the monitor, charge the ba�ery for 6-8 hours.

Step1: To test recep�on, determine a loca�on for the

camera that will provide the best view of your baby in

the crib (note: do not mount camera in permanent

loca�on un�l ini�al set up test completed). Plug

Adapter into wall outlet and turn camera power on.

Step2: Press and hold 'POWER/MENU' bu�on on

monitor for 5-seconds un�l the AXVUE showed on the

screen.Video should immediately appear on screen.

If video does not appear, go to page 5 'To pair

monitor and camera'. If video appears, the ini�al set

up test is complete,and you can install camera,

instruc�ons below.

Installation Camera: Place the camera on a ﬂat

surface, such as a bureau or shelf (Figure1) or mount

the camera on a wall (Figure 2). For example: On the

desk or cabinet or ﬁxed to the wall, make sure that at

least 3 feet from the crib, power lines should be

placed above or behind the camera, adjust the

camera angle, un�l the display see the en�re crib, or

do you think the best line of sight.

1. Pre-drill a hole in the wall, a 3/16" (4.8mm) drill bit.

2. Insert the wall anchor into the hole and with a hammer, tap gently on the end un�l the wall

anchor is ﬂush with the wall.

3. Tighten screw un�l only 1/4" (6.2mm) of the screw is exposed.

4. Insert camera Adapter into the camera's adapter jack.

5. Slide the back of the camera down onto the screw un�l the camera is secure to the wall.

6. Plug the Adapter into a standard electrical outlet.

7. Secure the cord to the wall using the security clips to keep cord away from baby's reach.

Features and components

WARNING

TESTING INITIAL SETUP

WALL-MOUNT

Figure 1

Fixing cable

with clip

Figure 2

PAGE 4