Axxess LC-CHRC-01 Kurulum Talimatları Kılavuzu - Sayfa 2
Kayıt Ekipmanları Axxess LC-CHRC-01 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Axxess LC-CHRC-01 8 sayfaları. Ram data interface 2013-2017
Sayfayı Yazdır
From the LC-CHRC-01 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
2
CONNECTIONS
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Connect the Yellow RCA jack the backup camera input.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
• Tape off and disregard the Blue/White wire, it will not be used in this application.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.