Arch AQF600-48S Hızlı Başlangıç Kılavuzu - Sayfa 4

Güç Kaynağı Arch AQF600-48S için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Arch AQF600-48S 5 sayfaları. Ac-dc switching power supply

Sayfayı Yazdır
AQF600 SERIES
FUNCTION DESCRIPITON of CN4
Pin No.
Function
Description
C1
+S
C2
-S
Current Share Function Pin
C3
CS
C4
GND
This pin connects to the negative terminal(-V). Return for DC-OK signal output.
C5
GND
This pin connects to the negative terminal(-V). Return for DC-OK signal output.
C6
+RC
Turns the output on and off by electrical or dry contact between pin C4 (-RC), Short: Power OFF, Open: Power ON.
C7
+PG
DC-OK Signal is a DC output, referenced to pinC6(DC-OK GND).
C8
+5V-AUX
Stand by voltage output ground 4.5~5.5V, referenced to pin C4 or C5(GND). The maximum load current is 0.6A.
FUNCTION MANUAL & APPLICATION NOTE
1. DC-OK Signal
Between DC-OK(pinC5)
and GND(pinC6)
3.7~5.7V
0~1V
2. Remote Control
It can be turned ON/OFF by using the "Remote Control" function.
Between RC+(pinC3) and
RC-(pinC4)
SW ON (Short)
SW OFF (Open)
3. Current Share
1. Difference in Vout among parallelled units should be less than +/-1%
2. Output Power at Parallel Operation = Rated Power per Unit x Number of Unit x 80%
3. Connect in parallel no more than 2 units. Please contact Arch for advice if more than 2 is needed.
4. Shorter wiring to each unit is recommended, as well as twisting +S and -S in pairs, as shown below
5. The remote sensing compensates voltage drop on the load wiring up to 5V
http://www.archcorp.com.tw
TEL: +886-2-26989508 FAX: +886-2-26981319
Output
Status
ON
OFF
Output
Status
OFF
ON
VER :
A_8
update :
2020.08.27
AC-DC Switching Power Supply
600 Watts
-4-