ABB RHD16000 Series Talimatlar Kılavuzu - Sayfa 15

Kontrolör ABB RHD16000 Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. ABB RHD16000 Series 17 sayfaları. Electrical part turn actuators for continuous modulating control (contrac)

Sayfayı Yazdır

11.3.2

Mounting

The toothed gear pair of the position sensor is held in place by a tension spring (3),

to ensure backlash-free motion when the direction of rotation is reversed.

- set the stop pin to the center position, as shown in Figure 14.

- align the sensor and its gears with the actuator; set the first toothed gear in

09:00 o'clock position (fig. 15) onto the drive shaft gear (4).

- slightly move the sensor back and forth to pre-tension the toothed gears with the

difference "z" until the second toothed gear snaps in.

- fasten the screws (1) tightly.

- fasten sensor cable plug on sensor pcb

(r00329x1)

Fig. 14: Position sensor

After mounting is completed readjust the actuator range as described in the setup

section of this manual.

sensor cable

Fig. 15: Mounting position (Example shows RHD 500)

position sensor