ABB Series Kullanıcı Kılavuzu - Sayfa 8

Kontrolör ABB Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ABB Series 12 sayfaları. Area controller

Communication Connections

Communication connections should be made with care. To avoid conflicts with existing networks, it is

recommended all communication configuration of the product be performed prior to connecting physical

media from the building automation system. Refer to Aspect Studio On-Line Help System for additional

information.

Caution: It is recommended that all software configuration be performed prior to physically connecting this to any

associated communication

Ethernet is a high-speed network layer widely used in commercial buildings. This product includes an on- board

Ethernet adapter, allowing users communicate with the device for product setup, as well as for building

automation routines and applications. The Ethernet network interface is located on the single board computer

card.

The on-board Ethernet network interface supports 10Base-T (10Mbps) and 100Base-T (100Mbps) Ethernet

connections. The product will automatically switch to 100Base-T operations if other devices and cabling

connected to the same subnetwork support this

Use an approved Category 5 (CAT5) Ethernet patch cable with RJ-45 plugs to connect the product to an

Ethernet switch or hub. Use professionally manufactured cables to assure reliable transmission rates and

connectivity between devices. Category 5 wiring is typically limited to about 100 meters (320 feet).

Subject to change without notice

WWW.CYLON.COM

MATRIX Series |

product networks.

Figure 1-7 Standard Ethernet Connection Pinout

Communication Connections