Ayra 9000-0007-4804 Kullanıcı Kılavuzu - Sayfa 9

DJ Ekipmanları Ayra 9000-0007-4804 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ayra 9000-0007-4804 18 sayfaları. Dmx led light set with power outputs

Sayfayı Yazdır
Ayra 9000-0007-4804 Kullanıcı Kılavuzu
The ComPar KIT series comes with a practical lighting tripod stand. Extract the feet of the stands until they
are fully extended. Pull the distance tube out until you reach a proper install height and tighten the knob. Use
the included safety pin to ensure that the stand will not be able to slide down. Place the ComPar KIT bar on
the stand. To activate the unit, connect the included power supply to the unit and a suitable 230V, 50 Hz
power outlet. The unit will activate directly after it is plugged in to a wall outlet or other power source.
The status of the fixture is shown on the display. Certain values determine the current status and will change
when you push buttons on the control panel. The buttons each have their own function, for easy navigation in
the control panel.
Display codes:
display
Mode
ADDR
DMX address setting
CHND
Channel mode
SLND
Slave mode
SHND
Show mode
SOUN
Sound mode
SENE
Sound sense
BLND
Black out mode
DISP
Display inversion
TEST
Test mode
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0

Setting up the unit

Creation date + author initials: 30-07-2013 RV Revision date + author initials: 11-02-2014 RV
Function
A001-A512
1 channel mode
3 channel mode
7 channel mode
12 channel mode
16 channel mode
Slave 1-2
Show 1 - Show 8
Sound on/off
Sound sense 0-100
LED mode, YES – NO
Display Inversion,Idsp-dspI
Self test
Description
Set the DMX start address
by choosing a value
between 1 and 512.
Select the DMX channel
mode, which will determine
how many channels the unit
will fill on your DMX
controller. More channels =
more specific functionality
NOTE: Only possible by
connecting two ComPar KIT
units with each other by 3p
XLR cable.
Set the unit to Slave 1 or 2.
In music mode, slave 2 will
switch between mirrored and
synced operation mode.
Slave 1 is standard synced
mode.
Select any internal automatic
show for stand-alone
applications
Activate or deactivate the
internal microphone and the
music-controlled mode
Select the sensitivity of the
internal microphone, for the
sound-active mode
Activates or deactivates the
beam output for the LED
projectors
Inverts the display, when the
unit is used upside-down as
large floorspot with floor
stands. This makes it easier
to read certain display
statuses.
Self-test program, projects
all colours separately. This
makes it possible to check if
there are broken LED
modules.