Ayra 9000-0019-1962 Kullanıcı Kılavuzu - Sayfa 10

DJ Ekipmanları Ayra 9000-0019-1962 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ayra 9000-0019-1962 18 sayfaları. Rgbawuv led moving head

Sayfayı Yazdır

The ERO 706 offers various operating modes, and each with its own advantages. For simple events there are

stand-alone modes, for advanced situations it's possible to create synchronised light shows. You can also

control every feature of the ERO 706 via DMX, in two channel modes. A short description for each mode can

be found below:

AutoRun:

Automatic light show with a pre-programmed internal show, on a pre-defined speed. Use the AutoRun modes

to activate the programs and set the speed. The speed of the internal programs can be adjusted from 0 to 9.

Sound:

Automatic light show with a pre-programmed internal show, in sync with the music, thanks to an internal

microphone that picks up the beat of the music and changes a step every time a beat is detected. Use the

Sound Sense mode to change the sensitivity of the internal microphone so it will respond optimally to the beat

of the music. In this mode, any set function in the AutoRun mode is overruled and the fixture will change

effects in sync with the beat of the music.

Slave:

In master/slave mode, it is possible to link several ERO 706 fixtures together, to create synchronised light

shows in the AutoRun or Sound mode. The first fixture in the chain must be set in the Auto or Music mode,

and the other fixtures must be set to Slave, so they will mimic the behaviour of the first fixture. The

master/slave function requires 3p XLR male – XLR female cables (not included). Connect the DMX out of the

master fixture to the DMX input of the second (and other slave) fixtures. You can also experiment with

inverting pan and tilt values, to create amazing mirrored light shows.

DMX:

The ERO 706 can be connected to a DMX controller with standard 3p XLR male – XLR female cable. In DMX

mode, a DMX terminator must be connected to the last fixture at the end of the DMX chain, to prevent

reflections in the DMX signal, which could cause flickering and unwanted behaviour from your intelligent

fixtures.

A DMX terminator is an XLR connector with a 120-ohm resistor placed between pin 2 and 3 as a bridge.

NOTE: The ERO 706 can be switched between two DMX modes. The only difference is that in the 15CH

mode you have control over pan and tilt fine values (for the precise aiming of your beams) and there are extra

functions to for triggering the music controlled mode and colour macros.

11CH mode:

Function

CH1

Pan movement

CH2

Tilt movement

CH3

Shutter/strobe channel

CH4

Dimmer Red 0-100%

CH5

Dimmer green 0-100%

All information and illustrations shown in this user manual are subject to change without further notice.

User manual version: 1.0

Operating modes

Creation date + author initials: 13-05-2015 RV Revision date + author initials:

Values

000-255

000-007 – Shutter closed

008-015 – LED quick start

016-131 – Strobe, slow to fast

132-139 – LED quick start

140-181 – Pulse, slow to fast

182-189 – LED quick start

190-231 – Inverted pulse, slow to fast

232-239 – LED quick start

240-247 – Strobe, slow to fast

248-255 – Shutter open

000-255