Ayra 9000-0019-1962 Kullanıcı Kılavuzu - Sayfa 7
DJ Ekipmanları Ayra 9000-0019-1962 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ayra 9000-0019-1962 18 sayfaları. Rgbawuv led moving head
Sayfayı Yazdır
To activate the unit, connect the appropriate included power cable to the unit and to a suitable 230V, 50Hz
power outlet.
During start-up, the stepping motors and other parts of the fixture need to calibrate. You might notice some
shaking and rattling of the fixture; this is perfectly normal if it lasts no longer than 30 seconds. During start-up
the display reads 'Ayra ERO 706' and the fixture can not be used. Do not try to enter the menu during start-
up. When the start-up is complete, the last used mode will be shown and the settings and values can be
changed. For a new product, this is usually the DMX mode with the value set to 001
Through the menu and the buttons below the display, you are able to adjust settings and read data from the
fixture.
Use the display and the menu buttons on the bottom to set preferences, change settings and scroll through
the menu. "Enter" is used to save a certain setting or preset; press "Menu" for at least 2 seconds to return to
the main menu.
The table below shows an explanation for every feature and value.
display
Mode
DMX Address
DMX address setting
Channel mode
Channel mode selection
Show mode
Show mode selection (for music
controlled mode)
AutoRun mode
Select automatic program with
user set speed
Slave mode
Slave mode selection
Black out
Fixture blackout during DMX
signal loss?
Sound State
Sound activated mode enabled or
disabled
Sound Sense
Sound sensitivity
White Balance
Adjust the white balance of the
beam output
Pan inverse
Invert the pan values
Tilt inverse
Invert the tilt values
Back light
Back light on/off during use when
the menu is no longer in use
Auto test
Internal test mode, for service
and maintenance purposes
Temp. check
Checkfixture temperature
Fan speed
Fan speed selection, complete
control
Fixture time
Number of hours the fixture has
been used
Firmware
Displays the current firmware
version
version, not user upgradeable
Reset
Use this mode to reset the fixture
without removing power
connectors
DMX Address: DMX address setting, used to determine the DMX starting channel. From this channel on,
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Setting up the unit
Creation date + author initials: 13-05-2015 RV Revision date + author initials:
Function
Address 001 ... 512
11 CH / 15 CH
Show 1 – 4
Show 1-4
Speed 1-9
Master
Slave 1
Slave 2
Yes
No
Sound mode on yes/no
Set sound sensitivity 0-100
Red 50-255
Green 50-255
Blue 50-255
Invert pan values yes/no
Invert tilt values yes/no
Back light yes/no
Internal testing mode, testing LED and pan/tilt
Head/body (switch with up/down)
Displayed temperature in Celsius
Auto run
Block up
Slow
Medium
Fastest
0000 - 9999
V1.0 - ....
Reset, shows Ayra ERO 706 on display