Cisco 400 Series Hızlı Başlangıç Kılavuzu - Sayfa 5
Anahtar Cisco 400 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 400 Series 8 sayfaları. Fasthub
10/100 series
Ayrıca Cisco 400 Series için: Yapılandırma Kılavuzu (40 sayfalar)
Sayfayı Yazdır
Connect the Hub to Other Network Devices
(continued)
Power outlet
rollover console cable
(Optional) Connect the
Console Cable
Make sure console port settings of the
1
FastHub 400M model match the
settings of the terminal, PC, or laptop.
The default settings of the hub console
port are 9600 baud, 8 data bits,
1 stop bit, no parity, and no flow
control.
Connect the rollover console cable to
2
the CONSOLE port on the hub.
Connect the other end of the rollover
3
cable to your terminal, PC, or laptop
(if necessary, use an appropriate
adapter, such as the supplied
RJ-45-to-DB-9 adapter).
From your terminal, PC, or laptop, start
4
the terminal emulation program.
RATING
CONSOL E
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
Console port
RJ-45-to-RJ-45
(supplied)
DC INPUTS FOR REMOTE
POWER SUPPLY
UP
10/100 BASE-TX
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
DC INPUT
STAT DUP 100
DOWN
MEDIA MODULE
(RJ-45)
RJ-45-to-DB-9
adapter (supplied)
Power Up the Hub
Connect one end of the power cord to
1
the hub and the other end to a power
source.
Note: You can use the internal power
supply and the Cisco 600W AC Redundant
Power System (RPS). Attach only the Cisco
RPS (model PWR600-AC-RPS) to the RPS
receptacle.
Wait approximately 2 minutes for the
2
hub to complete its power-on self-test
(POST).
After POST completes, the Continue
with configuration dialog? prompt
appears on the management station.
You can then follow the prompts to
assign IP information to the hub.
4