Cisco 9000 Series Yükleme - Sayfa 7

Anahtar Cisco 9000 Series için çevrimiçi göz atın veya pdf Yükleme indirin. Cisco 9000 Series 19 sayfaları.

Installing the Cisco MDS 9148V-K9 Switch

Step 1

Install two rack-mount brackets to the switch as follows:

a. Position a rack-mount bracket so that three of its screw holes are aligned to the screw holes on the side of the chassis.

You can align any three of the holes in the rack-mount bracket to three of the screw holes on the side of the chassis.

The holes that you use depend on the requirements of your rack and the amount of clearance. For more information

on clearance, see the

b. You can install the rack-mount bracket either at the front or rear of the chassis. The choice is determined by which

end of the chassis will be inserted into the rack first. If the rear end of the chassis is to be inserted first, then mount

the brackets on the front of the chassis, and vice versa.

Figure 2: Installing Rack-Mount Brackets on the Front Side of the Chassis

c. Secure the rack-mount bracket to the chassis using the three M4 screws and tighten each screw to 12 in-lb (1.36 N·m)

of torque.

d. Repeat

Step 1

distance from the front of the switch.

Step 2

If you are installing the chassis into an ungrounded rack, you must attach a customer-supplied grounding wire to the

chassis. However, if you are installing the chassis into a grounded rack, you can skip this step.

Step 3

Install the slider rails into the rack or cabinet, as follows:

a. Determine which two posts of the rack or cabinet you should use for the slider rails. Of the four vertical posts in the

rack or cabinet, two will be used for the rack-mount brackets, and the other two posts will have the slider rails.

General Requirements for Cabinets and

M4 screws

for the other rack-mount bracket on the other side of the switch, and be sure to position it in the same

Installing the Switch in a 4-Post Rack

Racks.

Rack-mount

Installing the Cisco MDS 9148V-K9 Switch