AccuStream Abrasive Regulator II Manuel - Sayfa 4

Kontrolör AccuStream Abrasive Regulator II için çevrimiçi göz atın veya pdf Manuel indirin. AccuStream Abrasive Regulator II 10 sayfaları.

AccuStream Cutting Systems

2 Abrasive Regulator

Description:

The Abrasive Regulator is positioned over the cutting head and is fed abrasive from the abrasive

delivery pot. The Regulator will provide an accurate metering and control of the abrasive flow rate. The

regulator uses an air cylinder to turn the abrasive flow to the cutting head ON or OFF. An adjustment

control knob is used to meter the abrasive rate to the cutting head.

The Metering Regulator is mounted to the Z-axis faceplate over the cutting head at up to 6' (feet) from

the floor level. This should be high enough to keep the regulator out of the spray-back area from the

cutting head and within reach for adjusting the abrasive flow rate.

Attaching the Regulator to the

Machine

1. Remove the back mounting plate from the

regulator. Use the mounting plate to position and

drill mounting holes on the machine.

NOTE: The holes on the mounting plate are

positioned 2 inches (50.8 mm) on center from each

other and counter bored for .25 (6.35 mm)

Capscrews.

2. Reassemble the back mounting plate to the

regulator.

3. Remove the bottom adapter from the regulator and

thread the rear tie rod upward so that there is

access to mount the regulator to the machine. Use

¼" (6 mm bolt) cap screws for mounting the

regulator.

4. Re-thread the tie rods back into their original

locations.

13096 Abrasive Regulator II Manual

Picture may differ from

your regulator

Inlet

3/8 inch (9.524 mm)

Back Mounting

Plate see Note

Rear

Tie Rod