Samsung U32R590 Kullanıcı Kılavuzu - Sayfa 34
Monitör Samsung U32R590 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Samsung U32R590 44 sayfaları.
Sayfayı Yazdır
PC/AV Mode
Set
PC/AV Mode
to AV. The picture size will be enlarged.
This option is useful when you view a movie.
•
Set to
PC
when connected to a PC.
•
Set to
AV
when connected to an AV device.
― Supplied for the wide models only such as 16:9 or 16:10.
― If the monitor (when set to HDMI, DisplayPort) is in power saving mode or is displaying the message
Signal
Cable, press the
icon to display the On Screen Display (OSD). You can select
DisplayPort Ver.
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI, DisplayPort) is in power saving mode or is displaying the message
Signal
Cable, press the
icon to display the On Screen Display (OSD). You can select
― If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.
HDMI Mode
Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
Check
device.
PC
or AV.
― Set the
HDMI Mode
― Not available when
― If the monitor(when set to HDMI) is in power saving mode or is displaying the message
press the
icon to display the On Screen Display(OSD). You can select
Source Detection
Check
1.1
or 1.2↑.
Select either
Auto
― Not available when
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
when a button is pressed.
to 1.4, some high resolutions may not be supported because of bandwidth
to
1.4
when there is no sound output from the DVD connected to our product.
PBP Mode
is set to On.
or
Manual
as the method to recognize input signal.
PBP Mode
is set to On.
2 sec
can be selected. If
No Repeat
is selected, a command responds only once
Check Signal
Cable,
1.4
or 2.0.
34