Ricoh SP3 Teknik Bülten - Sayfa 7

Yazıcı Ricoh SP3 için çevrimiçi göz atın veya pdf Teknik Bülten indirin. Ricoh SP3 28 sayfaları.

Sayfayı Yazdır
RTB Correction
Reissue date: 31-Jan-98
The items in bold italics have been added.
Model:
SP3
Subject:
Controller Error
From:
QAC Field Information Dept.
Classification:
A controller error was displayed due to a poor connection of the harness between the
controller board and the hard disk.
Problem
LEDs D2, 3, 5, and 6 or the LED D6 on the controller board were lit and a controller error
was displayed on the operation panel.
Cause
Due to a poor connection of the harness between the controller board and the hard disk,
the hard disk test cannot be executed.
Action
1. Check to see if the connector pins on the hard disk or the connector board are
deformed.
If the pins are deformed, fix them if possible. Replace them if they cannot be fixed.
2. Check to see if there is any foreign material on the connector. If so, please remove it.
3. Reset the harness.
When inserting the harness into the connector, enough force should be applied to
ensure that it is completely plugged in.
T
echnical

Troubleshooting

Mechanical
Paper path
Other (
)
B
ulletin
Date:
15-Jan-98
Prepared by:
Part information
Electrical
Transmit/receive
PAGE: 1/1
No:
5
E.Fukuyama
Action required
Service manual revision
Retrofit information