ActronAir CL01-2W Kurulum Talimatları Kılavuzu - Sayfa 4

Kontrol Paneli ActronAir CL01-2W için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. ActronAir CL01-2W 8 sayfaları. Control interface

Sayfayı Yazdır

Installation Guide

3. Mount back cover to the wall

• Mount the back cover to the wall with screws via screw

holes. If required, the use of a plasterboard mounting

bracket is recommended to mount the back cover to the

wall.

• Ensure that the Control Interface back cover is aligned and

leveled on the wall before tightening the screws.

BACK COVER

PLASTERBOARD

MOUNTING BRACKET

SCREW HOLES

5. Attach PCB casing to the back cover

• Attach the PCB casing by aligning with the back cover

mounted on the wall.

• Ensure the PCB casing makes a 'click' sound after

mounting.

BACK COVER

NOTE

Front cover can be removed even after installation. Press at

the bottom of the control interface and pull the front cover.

4. Connect wiring at the back of Control Interface

• Ensure that all wiring is tightly connected. All wiring must

be in accordance with the provided wiring diagram.

6. Attach the front cover, as shown in the diagram below

IMPORTANT

Ensure protective film is removed from inside of the front

cover before attaching.

• After attaching the front cover, check that the Control

Interface is aligned and leveled on the wall.

PCB CASING

Installation Guide - CL01-2 Control Interface Insert

Document: 9590-3026 Ver. 2 220907

CL01-2 Control Interface

POWER

485 A

485 B

GND

DO NOT CONNECT TRACE WIRE

TO CONTROL INTERFACE.

CUT WIRE, AS SHORT AS POSSIBLE,

IN ORDER TO PREVENT SHORTING.

BACK COVER

AS MOUNTED

ON THE WALL

TWISTED PAIR - 1

TWISTED PAIR - 2

FRONT COVER