Ace AF-33 Kullanım Kılavuzu - Sayfa 10

Test Ekipmanları Ace AF-33 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ace AF-33 16 sayfaları.

Sayfayı Yazdır

This way you receive a result

as accurately as possible:

a) Wait at least 15 minutes after your last sip of alcohol.

Do not eat, drink or smoke during that time.

b) Do not open the casing.

c) Do not keep the ACE AF-33 in cold, hot, moist or badly

ventilated places.

d) Keep the ACE AF-33 out of the reach of children.

e) Conduct three inlet tests after long storage before conducting

the actual alcohol test.

f) Do not let the ACE AF-33 fall.

g) Change batteries after battery alarm. Diminished battery

capacity leads to incorrect test results.

h) Do not conduct tests in loud (sound waves disrupt the sensor),

draughty or badly ventilated places.

i) After a test result of 1.00 per mille or higher the sensor needs

a resting time. In this case wait at least three minutes before the

next test.

j) Do not conduct tests in very cold, very hot or unventilated,

smoky ambience.

k) Store the ACE AF-33 in a way to avoid penetration by dust or

liquids.

l) Blowing too hard may cause damage to sensor as saliva flows

into sensor.

Preparation for the test:

1. Install 2 pieces of AAA batteries (alkaline, 1.5 V) in the battery

compartment. Remove the battery compartment cover at the

back of the device carefully and insert the 2 pieces of AAA

batteries. Mind the battery polarity in the process (+/-).

2. For the active mode operation put a mouthpiece on the

mouthpiece connection, which is on the side of the device.

Make sure it is attached properly. Use a different mouthpiece for

each test person. Avoid blowing cigarette smoke into the tester!

ACE Technik recommends:

Always use a new mouthpiece for each person and each test

which is conducted. ACE Technik assumes no liability for any

damages which arise when several people use the same mouth-

piece for multiple tests..

Don`t use the enclosed but the hygienic mouthpieces from the

ACE series! During each test the ACE AF-33 internal and external

gets in contact with human secretion (saliva, blood, sweat etc.)!

Use safety gloves when pulling out a mouthpiece which was

used by another person than yourself! You can buy appropriate

gloves at ACE Technik.

Conducting a measurement:

1. Press power button. The total

number of tests performed will be

displayed.

2. The remaining recalibration date

will be displayed after total number

of tests. The Blue LED on both side

of corner will flash with the message

of "CAL" on the screen when the

countdown reaches 0 day.

3. The countdown will be started

automatically, and begin to inhale a

deep breath when the countdown

approaches 2.