ACU-RITE 02027 Kullanım Kılavuzu - Sayfa 10

Hava İstasyonu ACU-RITE 02027 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ACU-RITE 02027 16 sayfaları.

Sayfayı Yazdır

1. Setup

LOW records.

To manually clear all of today's HIGH recorded values, press and hold the

" button for 2 seconds. Dashes display to confirm you have cleared the

HIGH records.

Press the "

" button to cycle through the all-time high and low recorded

values (one record is shown at a time) for outdoor and indoor temperature and

humidity. Located in the top right corner of the screen, a date and time stamp

are shown for when each value was recorded. You will automatically exit

all-time records if no buttons are pressed for 5 seconds.

To manually clear an all-time LOW record, press and hold the "

for 2 seconds while viewing the record you wish to clear. Dashes display to

confirm you have cleared the record.

To manually clear an all-time HIGH record, press and hold the "

for 2 seconds while viewing the record you wish to clear. Dashes display to

confirm you have cleared the record.

Troubleshooting

No outdoor sensor

reception

no bars

Display screen

not working

Outdoor

temperature

is flashing or

showing dashes

If the wireless signal indicator shows no bars:

• Relocate the display unit and/or the outdoor sensor.

The units must be within 330 ft (100 m) of each other.

• Make sure both units are placed at least 3 feet (.9

m) away from electronics that may interfere with the

wireless communication (such as TVs, microwaves,

computers, etc).

• Use standard alkaline batteries (or lithium batteries in

sensor when temperature is below -4ºF/-20ºC). Do not

use heavy duty or rechargeable batteries. NOTE: It

may take up to 20 minutes for display unit and sensor

to synchronize after batteries are replaced.

• Check that the batteries are installed correctly.

Batteries may need to be replaced.

• Reset display by pressing the RESET button, located

on the back of the display unit. Date and time will

need to be entered after a reset.

Flashing of the outdoor temperature is generally an

indication of wireless interference.

1. Bring both the sensor and display unit indoors and

remove at least one battery from each.

2. Make sure the A-B-C switch on both units match.

3. Reinstall the battery in the outdoor sensor.

4. Reinstall the battery in the display unit.

5. Let the units sit within a couple feet of each other

for about 20 minutes to gain a strong connection.

" button