CABINETS TO GO Findley & Myers VSB30DL Montaj Talimatları - Sayfa 2
İç Mekan Mobilyaları CABINETS TO GO Findley & Myers VSB30DL için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. CABINETS TO GO Findley & Myers VSB30DL 4 sayfaları. Vanity sink base w/drawer
Sayfayı Yazdır
► General Instructions:
Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed
to face the test of daily use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly, please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any
damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant
damage and/or injury.
Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.
Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will
not be held responsible for failure to follow these instructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT
1-800-CABINET.
Items Quantity
►
Item
Description
Face Frame with 2 Doors & 3 Drawer Fronts
A
B
Side Panels
C
Bottom Panel
D
Back Panel
E
Toe Kick
F
Drawer Box:
G
Hardware B ox:
Bumper 12pcs, Plastic corner bracket 4pcs, 1/2" round head screws 8pcs, 1" screws 10pcs, Slide Rails 2 Sets, Slide Rail Supports 4pcs
1/2" flat head screws for slides 12pcs
► Required tools:
Tools Required: Phillips Screwdriver
Optional Tools: Electric Drill
► Hardware Box:
a
b
c
d
12
Qty
4
8
Qty 10
Q ty
Qty
The materials listing above are for the largest unit in this instruction set. Smaller units may require less
hardware and materials; therefore, your item may contain a smaller number of each.
Front 2pcs, Back 2pcs, Sides 4pcs, Bottom 2pcs
Optional Tools: Rubber Mallet
e
f
g
Qty 4 (2 Sets)
Qty 12
Qty 4
(Drawer Fronts: 1 Long Fixed, 2 Short)
F
x2
Page 2
Qty
1
2
1
1
1
2
1
B
D
F
A
A
B
A
A
A
A
C
E