Cisco 3600 Series Yapılandırma Notu - Sayfa 12

Ağ Donanımı Cisco 3600 Series için çevrimiçi göz atın veya pdf Yapılandırma Notu indirin. Cisco 3600 Series 18 sayfaları. Memory upgrade
Ayrıca Cisco 3600 Series için: Ürüne Genel Bakış (10 sayfalar), Yükseltme Talimatları (30 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Uygulama Notu (41 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Ekler (15 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Manuel (5 sayfalar), Yapılandırma Notu (23 sayfalar), Yapılandırma Notu (25 sayfalar)

Wall-Mounting the Router

This section explains how to mount a Cisco 3620 or Cisco 3640 router on a wall. If you have

questions or need help with the wall-mounting procedure, refer to the section "Obtaining Service

and Support" later in this document.

If you are planning to wall-mount your router, do so before making network and power connections.

If you need to install network modules or WAN interface cards, you can do so either before or after

mounting the router, whenever you have better access to the rear of the router.

Note

structure.

Required Tools and Equipment

You need the following tools and equipment to install a Cisco 3600 series router on a wall:

•

Cisco Systems does not supply the board or screws.

Each router is shipped with one set of brackets. Brackets for 19-inch racks are shipped unless you

specify 23-inch or 24-inch brackets at the time of your order. The Cisco 3620 router uses 19-inch

rack brackets to mount on a wall, and the Cisco 3640 router uses 23-inch or 24-inch rack brackets

to mount on a wall. Figure 23 shows the wall-mount brackets.

Figure 23

Bracket for wall-mounting

Cisco 3620.

12 Cisco 3600 Series Rack-Mount and Wall-Mount Conﬁguration Note

When choosing a wall on which to mount the router, consider cable limitations as well as wall

Number 2 Phillips screwdriver

Small ﬂat-blade screwdriver (Cisco 3620 router only)

Plywood board at least 24 inches wide, 19 inches high, and 1/2 inch thick (60 x 50 x 1.3 cm)

Eight M3.5 or #6 x 1/2-inch ﬂat-head wood screws

Four wood screws, at least 3/16-inch x 2 1/2-inch, to mount the plywood to the wall

ESD-preventive wrist strap

Wall-Mount Brackets

Use with 23-inch rack

Use with 24-inch rack

Bracket for wall-mounting

Cisco 3640