Sony XC-ST50 Kullanıcı Kılavuzu - Sayfa 20

Dijital Kamera Sony XC-ST50 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Sony XC-ST50 31 sayfaları. Black-and-white video camera module
Ayrıca Sony XC-ST50 için: Teknik Özellikler (4 sayfalar), Ürün Kılavuzu (2 sayfalar), Teknik Kılavuz (30 sayfalar), Teknik Kılavuz (31 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

1. Connection Diagram

XC-ST50/50CE

XC-ST30/30CE

TIMING CHART OF EXTERNAL TRIGGER SHUTTER - MODE 1 (NON-RESET MODE)

For setting the shutter speed using TRG width

HD/VD input

Continuous HD input and single VD input

External trigger shutter operation

Trigger

Exposure time

External HD

External VD

(Single VD)

T : T = 10 s to 100 ms

Video out

WEN

1: This is a signal input from the outside. Be sure to input both HD and VD signals in this case. Make the

phase of the VD signal coincide with the falling edge of the HD signal during input operation.

2: Exposure time Te

(The trigger width should be between 2 s and 1/4 s)

3: The normal operation state is engaged when the trigger high period exceeds 1/3 sec. After that the external

trigger shutter operation is engaged when the trigger pulse goes "low". In this case, the area between the

falling edge of a trigger pulse and the subsequent 50 ms period is an external trigger input inhibition area.

During the trigger inhibit period, an input trigger may be missed.

4: Be sure to input an external VD signal between 10 s and 100 ms from the falling edge of a trigger pulse

(as shown by 1 and 2 in the figure). For the input (except described above), the operation cannot be

ensured. If the external VD signal is not input under the prescribed conditions, the normal operation is

engaged several V after a change in input operation under the prescribed conditions.

5: When the external trigger shutter mode changes into the normal operation mode, one WEN signal is

output.

Note

: An image is superimposed when the next exposure ends before the previous image is output.

250H

(XC-ST50/ST30)

293H

(XC-ST50CE/ST30CE)

Te = Trigger width + 97 s (XC-ST50/ST30)

Te = Trigger width + 120 s (XC-ST50CE/ST30CE)

Mode transition state

Normal operation

1/3 s or more

External input

External trigger

inhibition area

shutter operation

(50 ms)

Exposure

time

min 10 s

250H

(XC-ST50/ST30)

293H

(XC-ST50CE/ST30CE)