Cisco ASA 5545-X Yazılım Kılavuzu - Sayfa 19

Ağ Donanımı Cisco ASA 5545-X için çevrimiçi göz atın veya pdf Yazılım Kılavuzu indirin. Cisco ASA 5545-X 37 sayfaları. Threat defense reimage guide
Ayrıca Cisco ASA 5545-X için: Kurulum Talimatları Kılavuzu (13 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Hızlı Başlangıç Kılavuzu (15 sayfalar)

Cisco ASA and Firepower Threat Defense Reimage Guide

d) Load the ASA FirePOWER boot image:

sw-module module sfr recover boot

Example:

ciscoasa# sw-module module sfr recover boot

Module sfr will be recovered. This may erase all configuration and all data

on that device and attempt to download/install a new image for it. This may take

several minutes.

Recover module sfr? [confirm] y

Recover issued for module sfr.

e) Wait a few minutes for the ASA FirePOWER module to boot up, and then open a console session to the

now-running ASA FirePOWER boot image. You might need to press Enter after opening the session to

get to the login prompt. The default username is admin and the default password is Admin123.

Example:

ciscoasa# session sfr console

Opening console session with module sfr.

Connected to module sfr. Escape character sequence is 'CTRL-^X'.

asasfr login: admin

Password: Admin123

If the module boot has not completed, the session command will fail with a message about not being able

to connect over ttyS1. Wait and try again.

a) Configure the system so that you can install the system software install package.

setup

You are prompted for the following. Note that the management address and gateway, and DNS information,

are the key settings to configure.

Example:

asasfr-boot> setup

• Host name—Up to 65 alphanumeric characters, no spaces. Hyphens are allowed.

• Network address—You can set static IPv4 or IPv6 addresses, or use DHCP (for IPv4) or IPv6 stateless

autoconfiguration.

• DNS information—You must identify at least one DNS server, and you can also set the domain name

and search domain.

• NTP information—You can enable NTP and configure the NTP servers, for setting system time.

Welcome to Cisco FirePOWER Services Setup

Default values are inside []

[hit Ctrl-C to abort]

Cisco ASA and Firepower Threat Defense Reimage Guide

Reimage from Firepower Threat Defense to ASA