3Com MSR 30-16 Yayın Notu - Sayfa 16

Ağ Yönlendiricisi 3Com MSR 30-16 için çevrimiçi göz atın veya pdf Yayın Notu indirin. 3Com MSR 30-16 17 sayfaları. Safety and compliance information (v1.01)
Ayrıca 3Com MSR 30-16 için: Güvenlik Bilgileri Kılavuzu (12 sayfalar)

Sayfayı Yazdır

3Com MSR Family Release Notes

Release Notes Software v5.20

| <5> Change Ethernet Parameter

| <6> Exit To Main Menu

| < Ensure The Parameter Be Modified Before Downloading! >

=============================================================

Enter your choice(1-6):5

Select option 5 (Change Ethernet Parameter) to change the download parameters, as shown

in the example below.

Note: To modify the parameter values, enter the new values next to the existing values. Do not

use the Delete or Backspace key to erase the existing values.

Note: Two protocols for download, tftp & ftp.

You can modify the flags following the menu except the boot

device.

tftp--0x80, ftp--0x0.

'.' = clear field;

boot device

processor number

host name

file name

inet on ethernet (e) : 172.16.1.1

inet on backplane (b):

host inet (h)

gateway inet (g)

user (u)

ftp password (pw) (blank = use rsh):

flags (f)

target name (tn)

startup script (s)

other (o)

Table 5: Description on the download parameters

Parameter

Download boot device

Download file name

Target file name

Inet on ethernet

Host inet

Gateway inet

When the Ethernet SubMenu is re-displayed, select option 2 (Update Main Application File)

to download and write the application image to Flash memory. Depending on the running

code, the system display would look something like:

Attached TCP/IP interface to mottsec0.

'-' = go to previous field;

: mottsec0

: 0

: host

: msr50-cmw520-b1508p01-si.bin

: 172.16.1.254

: 0x80

Description

The Ethernet port for downloading; leave the default as is. The

physical port is usually the first Ethernet port(Eth 0/0 or GigE

0/0)

Name of the image file to be downloaded.

File name to be used on the router. If left blank, the current

filename for that application type will be used

IP address of interface eth0.

IP address of the server where the image is stored.

You must configure the gateway address if the server and the

router are not located on the same segment.

Ctrl+D = quit