Cisco PIX 501 Hızlı Başlangıç Kılavuzu - Sayfa 12

Ağ Donanımı Cisco PIX 501 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco PIX 501 21 sayfaları. Data sheet
Ayrıca Cisco PIX 501 için: Hızlı Başlangıç Kılavuzu (20 sayfalar), Veri Sayfası (8 sayfalar), Hızlı Başlangıç Kılavuzu (20 sayfalar), Hızlı Başlangıç Kılavuzu (18 sayfalar)

For information on how to access the PIX Firewall configuration mode, refer to the

Configuration Mode"

Configuration Guide.

You can also access the CLI using SSH/Telnet to the PIX Firewall. By default, SSH/Telnet access is not

permitted. Use PDM or the console to configure SSH/Telnet access to the PIX Firewall. To Telnet to

the PIX Firewall from the outside perimeter of the PIX Firewall, configure an outside IP address and

IPSec for a secure Telnet session. Refer to the

more information about how to use the CLI.

Check the LEDs

CISCO PIX 501

F I R E W A L L

The LINK/ACT LED indicators on the front panel of the PIX Firewall are normally solid green when

a link is established and flashing green when the ports are active. Each inside Ethernet interface

(numbered 1 through 4) has two LEDs to indicate the operating speed and that the physical link is

established.

If all LEDs are operating as expected (see Table 1), this concludes the hardware installation.

Note

Table 1

PIX 501 LEDs

LED

State

POWER

Green

Off

LINK/ACT

Flashing

green

Green

section in Chapter 1, "Getting Started" of the Cisco PIX Firewall and VPN

VPN TUNNEL

Description

The device is powered on.

The device is powered off.

Network activity, such as Internet access, is present.

The correct cable is in use, and the connected equipment has power.

Cisco PIX Firewall and VPN Configuration Guide

POWER

"Accessing

LINK/ACT

100 MBPS

for