Cisco PIX 501 Hızlı Başlangıç Kılavuzu - Sayfa 13

Ağ Donanımı Cisco PIX 501 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco PIX 501 21 sayfaları. Data sheet
Ayrıca Cisco PIX 501 için: Hızlı Başlangıç Kılavuzu (20 sayfalar), Veri Sayfası (8 sayfalar), Hızlı Başlangıç Kılavuzu (20 sayfalar), Hızlı Başlangıç Kılavuzu (18 sayfalar)

Table 1

PIX 501 LEDs (continued)

LED

State

Off

VPN TUNNEL Green

Off

100 MBPS

Green

Flashing

green

Description

No link is established.

Tip

If the LINK/ACT LED does not light up, you might be using the

wrong type of cable. Try replacing the yellow (straight-through)

Ethernet cable with the orange (crossover) Ethernet cable.

One or more IKE/IPSec VPN tunnels are active.

No VPN tunnels are active. The default configuration does not include a

VPN. Thus, the VPN tunnel LED will only be enabled if a VPN is added to

your configuration and a VPN tunnel is then established. Also, the LED

does not light up when PPTP/L2TP tunnels are established.

The interface is autonegotiated at 100-Mbps half or full duplex.

The interface is functioning at 10-Mbps half or full duplex.

With PIX Firewall Version 6.3, the PIX 501 outside interface

Note

(port 0) can autonegotiate to 10/100-Mbps half of full duplex,

but does not provide an external LED indicating 100 Mbps

operation. You must use PDM or the PIX CLI to verify the speed

and duplex setting of the interface.