Cisco TelePresence Server 7010 Değiştirme Talimatları Kılavuzu - Sayfa 9
Ağ Donanımı Cisco TelePresence Server 7010 için çevrimiçi göz atın veya pdf Değiştirme Talimatları Kılavuzu indirin. Cisco TelePresence Server 7010 18 sayfaları. 600w ac-input power supply and fan tray replacement
Ayrıca Cisco TelePresence Server 7010 için: Değiştirme Talimatları Kılavuzu (23 sayfalar), Kurulum Talimatları Kılavuzu (15 sayfalar), Kurulum Kılavuzu (14 sayfalar), Başlarken (16 sayfalar)
Sayfayı Yazdır
Removing and Replacing the Chassis Cover Panel
The two captive slotted screws are the only fasteners on the cover panel. (See Figure 5.) Five shallow
tabs at the bottom edge of the panel fit into slots at the base of the chassis opening. The tabs act as a
pivot point for pulling the top of the panel away from the chassis opening, and as guides to align the
panel when replacing it.
Figure 5
Warning
cable. When the power is on, high current is exposed on the fan tray and backplane.
Follow these steps to remove and replace the chassis cover panel:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
This completes the chassis cover panel removal and replacement procedure.
Removing and Replacing the Chassis Cover Panel
Captive screws
Before accessing the chassis interior, turn off the system power and unplug the power
On the front of the cover panel, use a 3/16-inch flat-blade screwdriver to loosen the two
captive screws. (See Figure 5.)
Pull the top of the panel out about three inches, then grasp the sides of the panel and pull it
up and away from the chassis.
To replace the cover panel, hold the sides of the panel with both hands and tilt the top of
the panel back slightly (toward you).
Slide the guide tabs into the slots in the bottom edge of the chassis. (See Figure 5.)
Using the guides as a pivot point, push the top half of the panel back toward the chassis
opening until the panel is flush with the edges of the chassis.
Hold the top front of the panel in place, if necessary, while you tighten the two captive
slotted screws with a 3/16-inch, flat-blade screwdriver.
600W AC-Input Power Supply and Fan Tray Replacement Instructions
Replacing Components
9