Cisco VIP4-50= Kurulum ve Yapılandırma Kılavuzu - Sayfa 34
Ağ Donanımı Cisco VIP4-50= için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma Kılavuzu indirin. Cisco VIP4-50= 44 sayfaları. Fourth generation versatile interface processor
Sayfayı Yazdır
VIP4 Maintenance Procedures
Caution
To prevent ESD damage when working with DIMMs: handle the DIMM by the card edges only, place a
removed DIMM on an antistatic mat, and store it in an antistatic container.
Place the DIMM in an antistatic container to protect it from ESD damage.
Step 6
This completes the DIMM removal procedure.
Installing SDRAM DIMMs
Caution
The DIMM is a sensitive component that is susceptible to ESD damage. Handle the DIMM by the edges
only; avoid touching the memory modules, pins, or traces (the metal fingers along the connector edge of
the DIMM). To prevent ESD damage, handle the DIMM as shown in
With the VIP4 in the same orientation as the previous procedure (with the handle away from you and the
bus connector toward you), use the following procedure to install the new DIMM in the DIMM socket:
Remove the new DIMM from its antistatic container.
Step 1
Step 2
Hold the DIMM between your thumbs and forefingers. (See
Note
The 64-MB DIMM should be facing component-side down.
Step 3
Insert the connector edge of the DIMM straight into the socket.
When inserting the DIMM, use firm but not excessive pressure. If you damage a socket, you will have
Caution
to return the VIP4 to the factory for repair.
Gently push the DIMM into the socket until the socket tabs close over the ends of the DIMM. (See
Step 4
Figure
Figure 8
When the DIMM is installed, check to see it is seated properly. If the DIMM appears misaligned,
Step 5
carefully remove it and reseat it in the socket. Push the DIMM firmly back into the socket until first one
and then the other socket tab moves into place.
Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide
34
8.) If necessary, rock the DIMM gently back and forth to seat it properly.
Inserting the DIMM
Figure
7.
Figure
7.)
OL-3673-01