Cisco C480M5 Kurulum Kılavuzu - Sayfa 9

Sunucu Cisco C480M5 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco C480M5 19 sayfaları.

Installing the Server

Installing the Cable Management Arm (Optional)

Note

The cable management arm (CMA) is reversible left-to-right. To reverse the CMA, see

Management Arm (Optional), on page 10

Step 1

With the server pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the server onto the

end of the stationary slide rail that is attached to the rack post. Slide the tab over the end of the rail until it clicks and

locks.

Figure 5: Attaching the CMA to the Rear Ends of the Slide Rails

CMA tab on arm farthest from server attaches

to end of stationary outer slide rail.

CMA tab on arm closest to the server attaches

to end of inner slide rail attached to server.

Step 2

Slide the CMA tab that is closest to the server over the end of the inner rail that is attached to the server. Slide the tab

over the end of the rail until it clicks and locks

Step 3

Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your

rack.

Step 4

Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached

to the rack post. Slide the tab over the end of the rail until it clicks and locks.

Installing the Cable Management Arm (Optional)

before installation.

CMA tab on width-adjustment slider attaches

to end of stationary outer slide rail.

Rear of server

Reversing the Cable

Installing the Server