Cisco Firepower 2130 Başlarken - Sayfa 18

Sunucu Cisco Firepower 2130 için çevrimiçi göz atın veya pdf Başlarken indirin. Cisco Firepower 2130 42 sayfaları. Rack-mount and ground the chassis
Ayrıca Cisco Firepower 2130 için: Manuel (12 sayfalar), Dağıtım Kılavuzu (8 sayfalar), Kurulum ve Bakım (26 sayfalar)

Sayfayı Yazdır

Cabling for the Firepower 9300

Perform the initial Firepower Threat Defense configuration on the logical device Management interface. You

can later enable management from any data interface. The Firepower Threat Defense device requires internet

access for licensing and updates, and the default behavior is to route management traffic to the gateway IP

address you specified when you deployed the device. If you want to route management traffic over the

backplane to the data interfaces instead, you can configure that setting in the FDM later.

Cable the following interfaces for initial chassis setup, continued monitoring, and logical device use.

• Console port—Connect your management computer to the console port to perform initial setup of the

• Chassis Management port—Connect the chassis management port to your management network for

• Logical device Management interface—Use one or more interfaces to manage logical devices. You can

• Data interfaces—Connect the data interfaces to your logical device data networks. You can configure

Getting Started

chassis. The Firepower 9300 includes an RS-232–to–RJ-45 serial console cable. You might need to use

a third party serial-to-USB cable to make the connection.

configuration and ongoing chassis management.

choose any interfaces on the chassis for this purpose other than the chassis management port, which is

reserved for FXOS management. Management interfaces can be shared among logical devices, or you

can use a separate interface per logical device. Typically, you share a management interface with all

logical devices, or if you use separate interfaces, put them on a single management network. But your

exact network requirements may vary.

physical interfaces, EtherChannels, and breakout ports to divide up high-capacity interfaces. You can

cable multiple logical devices to the same networks or to different networks, as your network needs

dictate. All traffic must exit the chassis on one interface and return on another interface to reach another

logical device.

For High Availability, use a Data interface for the failover/state link.

Getting Started