Cisco SFS 7008P Kurulum ve Yapılandırma Kılavuzu - Sayfa 11
Sunucu Cisco SFS 7008P için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma Kılavuzu indirin. Cisco SFS 7008P 34 sayfaları. Infiniband server switch
Sayfayı Yazdır
To install the Host Channel Expansion Card for IBM BladeCenter drivers after you have installed the
HCA Expansion Card, follow these steps:
Locate your downloaded software direcory.
Step 1
Open a terminal or graphic window and access the top-level directory.
Step 2
Execute the command ./tsinstall in a terminal window.
Step 3
# cdmount ./tsinstall
This program automatically detects the available kernel and installs the appropriate drivers as RPM
packages. By default, the files are saved in the /usr/local/cisco directory.
Configure the IPoIB driver by assigning an IP address to interface ib0 and/or ib1, which corresponds to
Step 4
the two HCA ports. IPoIB drivers load when the interfaces are used for the first time. To assign ib
interfaces, enter ifconfig ib# ip address netmask netmask.
This example configures one HCA:
# ifconfig ib0 192.168.0.1 netmask 255.255.255.0
#
# ifconfig ib1 192.168.1.1 netmask 255.255.255.0
#
This example configures two HCAs:
# ifconfig ib0 192.168.0.1 netmask 255.255.255.0
#
# ifconfig ib1 192.168.1.1 netmask 255.255.255.0
#
# ifconfig ib2 192.168.2.1 netmask 255.255.255.0
#
# ifconfig ib3 192.168.3.1 netmask 255.255.255.0
#
Merge ib0 and ib1 for port-to-port redundancy, if desired.
Step 5
(Optional) Configure MPI by following these steps:
Step 6
Make sure that your connections to the HCA uses port 1 of the first HCA. MPI requires the use of
•
HCA 1, port 1.
Set up rsh or ssh on two nodes so that you can run commands between a remote and local node
•
without entering a login or password. This is required to use the MPI protocol.
Either add paths to your environment PATH:
•
Add directories to your PATH variable. For example:
Step 7
Configure all other drivers, including SDP.
78-17434-01 Rev. A0
/usr/local/cisco/mpi/mpich/bin
/usr/local/cisco/bin
or
export PATH=$PATH:/usr/local/cisco
Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note
Installing the Cisco SFS 7008P Switch into a Rack
11