Cisco SNS-3595-K9 Yazılım Kurulumu - Sayfa 35
Sunucu Cisco SNS-3595-K9 için çevrimiçi göz atın veya pdf Yazılım Kurulumu indirin. Cisco SNS-3595-K9 38 sayfaları.
Ayrıca Cisco SNS-3595-K9 için: Kurulum Kılavuzu (36 sayfalar)
Install Cisco ISE Software on Cisco SNS Appliances
Prompt
Username
Password
When you create a password for the administrator during installation or after installation in the CLI, do not use
Note
the $ character in your password, unless it is the last character of the password. If it is the first or one of the
subsequent characters, the password is accepted, but cannot be used to log in to the CLI.
If you inadvertently create such a password, reset your password by logging into the console and using the CLI
command, or by getting an ISE CD or ISO file. Instructions for using an ISO file to reset the password are
explained in the following document:
identity-services-engine/200568-ISE-Password-Recovery-Mechanisms.html
After the setup program is run, the system reboots automatically.
Now, you can log in to Cisco ISE using the username and password that was configured during the setup process.
Verify the Installation Process
To verify that you have correctly completed the installation process:
Step 1
When the system reboots, at the login prompt enter the username you configured during setup, and press Enter.
Step 2
At password prompt, enter the password you configured during setup, and press Enter.
Step 3
Verify that the application has been installed properly by entering the show application command, and press Enter.
The console displays:
Cisco Identity Services Engine
---------------------------------------
Version: 2.0.1.116
Build Date: Mon Jan 11 19:31:27 2016
Install Date: Tue Jan 12 14:35:24 2016
Description
Identifies the administrative username
used for CLI access to the Cisco ISE
system. If you choose not to use the
default (admin), you must create a new
username. The username must be three
to eight characters in length and
comprise of valid alphanumeric
characters (A–Z, a–z, or 0–9).
Identifies the administrative password
that is used for CLI access to the Cisco
ISE system. You must create this
password in order to continue because
there is no default password. The
password must be a minimum of six
characters in length and include at least
one lowercase letter (a–z), one
uppercase letter (A–Z), and one
numeral (0–9).
https://www.cisco.com/c/en/us/support/docs/security/
Install Cisco ISE Software on Cisco SNS Appliances
Verify the Installation Process
Example
admin (default)
MyIseYPass2
35