Cisco ASR 5000 Kurulum Kılavuzu - Sayfa 13

Ağ Geçidi Cisco ASR 5000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco ASR 5000 33 sayfaları. Applying power and verifying the installation
Ayrıca Cisco ASR 5000 için: Kurulum Kılavuzu (18 sayfalar), Kurulum Prosedürü (8 sayfalar), Kurulum Kılavuzu (37 sayfalar)

Sayfayı Yazdır
Cisco ASR 5000 Kurulum Kılavuzu
Troubleshooting
Table 11: SPIO Run/Fail LED States
Color
Description
Green
Card powered with no errors
detected.
Red
Card powered with error(s)
detected.
None
Card is not receiving power.

SPIO Active LED States

The Active LED on the SPIO indicates that the software is loaded on the card and that the card is ready for
operation. For the SPIO installed in chassis slot 24, this LED should be green for normal operation. For the
SPIO installed in slot 25, this LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 12: SPIO Active LED States
Color
Description
Green
Card is active.
None
Card is not receiving power.
OR
Card in Standby Mode.
Troubleshooting
None needed.
Errors were detected during the Power On Self Tests (POSTs). It is likely that
the errors were logged to the command line interface during the boot process.
Refer to Monitoring the System for information on determining the status of
system hardware components.
Verify that the POWER LEDs on the PFUs are green. If they are not, check PFU
power feeds.
Verify that the power source is supplying ample voltage and current to the
chassis.
Verify that the card is properly installed per the instructions in the ASR 5000
Installation Guide.
If all of the above suggestions have been verified, it is possible that the SPIO
is not functional. Please contact your service representative.
Troubleshooting
None needed for SPIO in slot 24. If green for SPIO in slot 25, then verify that
SPIO in slot 24 is installed properly.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, the card is not receiving power.
Check the state of the Standby LED. If it is green, the card is in standby mode.
This is normal for the SPIO in slot 25 since the chassis automatically places the
card into standby mode at boot up.
ASR 5000 System Administration Guide, StarOS Release 21.2
Checking the LEDs on the SPIO
13