Cisco C1100TG-1N32A Donanım Kurulum Kılavuzu - Sayfa 20

Ağ Geçidi Cisco C1100TG-1N32A için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco C1100TG-1N32A 44 sayfaları. Terminal gateway

Power Guidelines and Requirements

• Baffles can help to isolate exhaust air from intake air, which also helps to draw cooling air through the

• When equipment installed in a rack (particularly in an enclosed rack) fails, try operating the equipment

Power Guidelines and Requirements

Check the power at your site to ensure that you are receiving power that is free of spikes and noise. Install

power conditioner if necessary.

The following sections describe the cables and thee specifications required to install Cisco 1100 Series ISRs:

The Cisco 1100 Terminal Gateway Routers has EIA/TIA-232 asynchronous (RJ-45) and ASYNC ports. The

console port does not have any hardware flow control.

Depending on the cable and the adapter used, this port appears as a DTE or DCE device at the end of the

cable. Only one port can be used at the same time.

The default parameters for the console port are 9600 baud, 8 data bits, 1 stop bit, and no parity. The console

portdoes not support hardware flow control. For detailed information about installing a console terminal, see

the Connecting to a Console Terminal or Modem section.

For cable and port pinouts, see the Cisco Modular Access Router Cable Specifications document located on

Cisco.com.

The router includes an asynchronous serial console port. The console ports provide access to the router using

a console terminal connected to the console port. This section discusses important cabling information to

consider before connecting the router to a console terminal or modem.

Console terminals send data at speeds slower than modems do; therefore, the console port is ideally suited

for use with console terminals.

When setting up your router, consider distance limitations and potential electromagnetic interference (EMI)

as defined by the applicable local and international regulations.

Network connection considerations are provided for:

Hardware Installation Guide for the Cisco 1100 Terminal Gateway

chassis. The best placement of the baffles depends on the airflow patterns in the rack, which can be found

by experimenting with different configurations.

by itself, if possible. Power off other equipment in the rack (and in adjacent racks) to allow the router

under test a maximum of cooling air and clean power.

Prepare for Router Installation